ingcool 7 Inch Capacitive Touchscreen Monitor IPS Display 1024×600 7″ HDMI LCD Module for Raspberry Pi 4B/ 3B+/A+/B/ 2B/ B+/A+/ Zero W, Support Windows 10/8.1/8 / 7

Introduction

Ingcool 7-inch Capacitive Touch Screen LCD, IPS Display, 1024×600 resolution, HDMI interface, which supports Raspberry Pi and can also be used as a computer monitor.

Development Resources

http://www.ingcool.com/wiki/7DP-CAPLCD?Amazon

FAQ

Why the LCD doesn’t work with Raspberry Pi?

Download the latest version of the system image on the Raspberry Pi official website write to the TF card, Make sure the system image in TF card is burnt correctly (Please refer to the WIKI:http://www.ingcool.com/wiki/7DP-CAPLCD?Amazon) The PWR will keep on and the ACT will keep blinking when the Raspberry Pi starts up successfully. it is possible that the image was burnt incorrectly OR the TF card was in bad contact if  both of the two LEDs keep on.

What should I do if I connect to the PC with LCD and it cannot display normally?

Please check if you connect all the cables properly, connect the touch cable first and then the HDMI cable, replug them and test it again. You may need to restart PC if the PC doesn’t support hot-plug.

What should I do if the display flicker?

because of the low voltage problem of USB port, if you face such a problem,you can use a 5V/3A power adapter for the Raspberry Pi other than USB connection, otherwise the Pi may failed to start up.

What should I do if the screen has the ghosting problem?

Adjust the adjustable potentiometer on the back. After the desktop is displayed, adjust the potentiometer to the best display effect, and then leave the screen for a while and wait for the ghost to disappear (it may take several hours).

Package Content

1 x7DP-CAPLCD

1 xHDMI cable

1 xHDMI to Micro HDMI Adapter

1 xUSB type A plug to micro B plug cable

1 xTrangle bracket

Make sure this fits by entering your model number.
【High Resolution】7 inch IPS screen with 1024×600 hardware resolution
【Widely Compatibility】Compatible with mini PC like Raspberry Pi 4 Model B/ 3B+/A+/B/ 2B/ B+/A+/ Zero WH/Zero W/Zero. When the LCD working with Raspberry Pi Zero WH/Zero W/Zero, you need to prepare additional mini HDMI adapter and USB cable
【Sensitivity Touch】Supports single touch for Raspberry Pi, Raspbian, Ubuntu, Kali, Retropie and WIN10 IoT, Free drive. Supports five points touch for windows system 10 / 8.1 / 8 / 7, Free drive
【Wider Viewing Angle 】The IPS screen provides 170° wide viewing angle for a great viewing experience
【Backlight Adjustment 】7″ Touchscreen display supports backlight control, low power consumption, increasing the lifetime of the display